Nokia 1221 - . ADDITIONAL SAFETY INFORMATION

50

Copyright © 2004 Nokia

Vehicles

RF signals may affect improperly installed or inadequately shielded electronic systems in
motor vehicles such as electronic fuel injection systems, electronic antiskid (antilock) braking
systems, electronic speed control systems, air bag systems. For more information, check with
the manufacturer or its representative of your vehicle or any equipment that has been added.

Only qualified personnel should service the device, or install the device in a vehicle. Faulty
installation or service may be dangerous and may invalidate any warranty that may apply
to the device. Check regularly that all wireless device equipment in your vehicle is mounted
and operating properly. Do not store or carry flammable liquids, gases, or explosive materials
in the same compartment as the device, its parts, or enhancements. For vehicles equipped
with an air bag, remember that an air bags inflate with great force. Do not place objects,
including installed or portable wireless equipment in the area over the air bag or in the air
bag deployment area. If in-vehicle wireless equipment is improperly installed and the air
bag inflates, serious injury could result.

Potentially explosive environments

Switch off your device when in any area with a potentially explosive atmosphere and obey
all signs and instructions. Potentially explosive atmospheres include areas where you would
normally be advised to turn off your vehicle engine. Sparks in such areas could cause an
explosion or fire resulting in bodily injury or even death. Switch off the device at refuelling
points such as near gas pumps at service stations. Observe restrictions on the use of radio
equipment in fuel depots, storage, and distribution areas, chemical plants or where blasting
operations are in progress. Areas with a potentially explosive atmosphere are often but not
always clearly marked. They include below deck on boats, chemical transfer or storage
facilities, vehicles using liquefied petroleum gas (such as propane or butane), and areas
where the air contains chemicals or particles such as grain, dust or metal powders.

FCC regulations prohibit using your wireless device while in the air. The use of wireless
telephones in an aircraft may be dangerous to the operation of the aircraft, disrupt the
wireless telephone network, and may be illegal.

Failure to observe these instructions may lead to suspension or denial of telephone services
to the offender, legal action, or both.

51

Copyright © 2004 Nokia

Reference Information

EMERGENCY CALLS

Important: Wireless phones, including this phone, operate using radio signals,
wireless networks, landline networks, and user-programmed functions. Because of
this, connections in all conditions cannot be guaranteed. You should never rely solely
on any wireless phone for essential communications like medical emergencies.

To make an emergency call:

1

If the phone is not on, switch it on. Check for adequate signal strength.

2

Press the End key as many times as needed to clear the display and ready the phone
for calls.

3

Key in the official emergency number for your present location. Emergency numbers
vary by location.

4

Press the Talk key.

If certain features are in use, you may first need to turn those features off before you can
make an emergency call. Consult this guide or your service provider. When making an
emergency call, give all the necessary information as accurately as possible. Your wireless
phone may be the only means of communication at the scene of an accident. Do not end
the call until given permission to do so.

52

Copyright © 2004 Nokia

CERTIFICATION INFORMATION (SAR)

NOKIA PHONE MODELS MEET THE GOVERNMENT'S REQUIREMENTS FOR EXPOSURE TO
RADIO WAVES.

Your wireless phone is a radio transmitter and receiver. It is designed and manufactured not to
exceed the emission limits for exposure to radio frequency (RF) energy set by the Federal
Communications Commission of the U.S. Government. These limits are part of comprehensive
guidelines and establish permitted levels of RF energy for the general population. The guidelines
are based on standards that were developed by independent scientific organizations through
periodic and thorough evaluation of scientific studies. The standards include a substantial
safety margin designed to assure the safety of all persons, regardless of age and health.

The exposure standard for wireless mobile phones employs a unit of measurement known
as the Specific Absorption Rate, or SAR. The SAR limit set by the FCC is 1.6W/kg.* Tests for
SAR are conducted using standard operating positions accepted by the FCC with the phone
transmitting at its highest certified power level in all tested frequency bands. Although the
SAR is determined at the highest certified power level, the actual SAR level of the phone
while operating can be well below the maximum value. This is because the phone is designed
to operate at multiple power levels so as to use only the power required to reach the network.
In general, the closer you are to a wireless base station antenna, the lower the power output.

Before a phone model is available for sale to the public, it must be tested and certified to the
FCC that it does not exceed the limit established by the government-adopted requirement
for safe exposure. The tests are performed in positions and locations (for example, at the ear
and worn on the body) as required by the FCC for each model. The highest SAR values as
reported to the FCC are as follows:

(Body-worn measurements differ among phone models, depending upon available accessories
and FCC requirements). While there may be differences between the SAR levels of various
phones and at various positions, they all meet the government requirement.

The FCC has granted an Equipment Authorization for these phone models with all reported
SAR levels evaluated as in compliance with the FCC RF exposure guidelines. SAR information
on these model phones is on file with the FCC and can be found under the Display Grant
section of http://www.fcc.gov/oet/fccid after searching on FCC ID L JPNKC-1X for the Nokia
1220 and Nokia 1221 phones or L JPNKW-1X for the Nokia 1260 phone.

When tested for use at
the ear

When worn on the body, as
described in this user guide

Nokia 1220 phone

1.19 W/kg

1.06 W/kg

Nokia 1221 phone

1.19 W.kg

1.06 W/kg

Nokia 1260 phone

1.23 W/kg

1.02 W/kg

53

Copyright © 2004 Nokia

Reference Information

For body-worn operation, these Nokia phone models have been tested and meet the FCC RF
exposure guidelines for use with an accessory that contains no metal and that positions the
handset a minimum of 7/8-inch (2.2 cm) from the body. Use of other accessories may not
ensure compliance with the FCC RF exposure guidelines.

*In the United States and Canada, the SAR limit for mobile phones used by the public is 1.6
watts/kilogram (W/kg) averaged over one gram of tissue. The standard incorporates a
substantial margin of safety to give additional protection for the public and to account for
any variations in measurements. SAR values may vary depending on national reporting
requirements and the network band. For SAR information in other regions please look under
product information at www.nokia.com.